Whether you just purchased your first Lampe Berger or you are looking for a refresher on how to re-fill it, follow the instructions below for optimal use!

Step 1

Place your Lampe Berger on a stable surface away from any source of heat. Remove the openwork shade and the cap.

Step 2

Fill your Lampe Berger full with Lampe Berger Parfum de Maison leaving enough room for the insertion of the wick. Wipe the Lampe Berger carefully of excess fluid. Due to the new material of the burner, using any other fragrance other than Parfum de Maison will effect and eventually clog the burner and ruin it!

Step 3

Insert the wick fully into the neck of the Lampe Berger, then check to make sure the burner is inserted. Place the cap on the neck and leave the wick to soak for a full 20 minutes, no less than the time instructed.

Step 4

Light the burner (E) using a lighter or match. Light the burner and leave the flame to burn for a complete 2 minutes. No less, no more.

Step 5

Blow out the flame. Warning: never place the openwork shade over the flame.

Step 6

Your Lampe Berger is now operating. Never touch the burner during operation. Place the openwork shade over the burner.

Step 7

To extinguish your Lampe Berger, remove the openwork shade and place the cap on the burner then place the openwork shade on the lamp. When relighting your Lampe Berger we recommend that the lamp is at a minimum of half full. After relighting your Lampe Berger, if it stops working after a few minutes, then relight it again and it will work.